Universal 8mm Car Clips - 50pcs Nylon Fastener Rivets for Auto Trim & Panels

Works perfectly! They fit where they needed towill buy more once I'm out of theseFit perfectly. The head diameter looks to be a little larger than the factory ones and they are flatter when installed. My ATV is tan but the differences in size is not noticeable. Darker colored machines will probably be even less obvious, of course one could replace all the push pins as these are inexpensive enough. I have to remove the inner fender of my Chrysler Crossfire and if these fit I will use them there too. Got here very quickly and am happy with them. Did not get the cost from the dealer but no matter as I did not have to drive to get them.It WorksJust what I needed for the mud flaps on our 2006 Tacoma.These work but they could be a little more snug. It felt like I could pull them back out after clicking the center in if I pulled very hard. However, despite the distance and some rough roads they have stayed in. But still, a little more of a snug fit wouldn't hurt at all.Works good doest brakenice to have available when you may need themI tried replacing 6 front fascia fasteners on my 2005 Dodge Magnum with these. They install and push in easily enough, but 4 of the 6 had the middle pin head crack right off when trying to remove them. Worse, they don't crack off AROUND the center push-pin, as the OEM ones do; they shear right off flush with the thicker base part of the fastener, making it impossible to remove the broken fastener with a fastener removal tool! I'm now going to have to pound the center pins downward through the bottom of the outer fastener bases just to get these garbage fasteners out. ONLY buy these (at least this brand) if you plan to only install them ONCE, and never need to remove them afterward.Ces rivets sont de fabrication solide ! Dans certains trous étroits, ils peuvent être difficiles à fixer, alors je met un petit peu de gelée de pétrole, là où se trouve la petite coche et j'emploie un petit marteau et..... le tour est joué ! merci.Went to the stealership looking to replace one that got lost. They quoted me fourteen dollars for a single clip. Now for the same price I have a pack of fity. I don't care if it turns out they spontaneously combust and have to be replaced every month, still a great value.Great replacement clips. As, I had to replace my headlights when they burnt out. Removal of the front bumper was required to gain access to the removal of the headlight hosing unit. (Which is totally dumb) While removing the bumper, of course, you end up breaking off some of the clips due to wear and tear or depending on where they are, they just snap off. A bag of 50 is more than what I needed, but just in case I have to replace the headlights again, hopefully not any time soon, I have spares.I received this product yesterday. After assembling all the pieces together, I counted 46 fasteners, two of the "Part 2" pieces were broken.Normally I wouldn't mind a few missing pieces/fasteners, but for the amount I paid, I believe it's fair to bring up.